patrick.net

Metalworker demonstrates structural steel bars bending at 1800F

Manipulation of data, that what it is.
Passenger commercial planes use JET A-1 as a fuel due to withstanding low temperature existed on high altitude.
This fuel is internationally regulated and is based on kerosene. Per producers' specification flush-point is 38C (100,4F) open air flame has temp, 210C (410F), however oxygen access and its temperature make impact on final temperature.
Temperature of 1500 degrees F exist only when fire occurs inside jet engine where mix of air and fuel is compressed before ignition.
Building is not an engine. Remaining fuel get spill loose from fuel tank located inside wings.
Video of metal worker test is busted.

REpro says

Building is not an engine. Remaining fuel get spill loose from fuel tank located inside wings.
Video of metal worker test is busted.

Nope. But burn a couch. A stack of papers. Carpet. Likely natural gas lines broken. No working sprinkler systems. It wasn't just jet fuel. People need to get over that.

I've burned a couch and almost got arrested. It's not a joke. Everything starts on fire in a building. You're not just talking about jet fuel. I know experts in this field. I hang out weekly with one. The steel melted. Find some loon that's wrong. I'll go with people that know what they're talking about. It was also bent from the impact so melt temperature is almost certainly lower before failure. Just because it burns @ 1,500º doesn't mean it can't melt bent steel either.

Building 7 is still the one I'll go with for a conspiracy. That one doesn't make sense. The towers though. An object mostly fully loaded with heavy fuel going 300-400 knots? Even if there was a way to recreate it without fuel on the plane the building doesn't last. Wind sheer at those heights is 100mph worse case in NY. This was 5-8x's that with weight behind it. You don't need to be an engineer to figure it out.

I saw several steel framed buildings after fire. None of them collapsed to dust. One which had a lot of paint products stored, had some explosion inside, get really high temp. Yet, get steel twisted but did not collapse. Others stand straights all the time. WookieMan says

I've burned a couch and almost got arrested. It's not a joke. Everything starts on fire in a building. You're not just talking about jet fuel. I know experts in this field. I hang out weekly with one. The steel melted. Find some loon that's wrong. I'll go with people that know what they're talking about. It was also bent from the impact so melt temperature is almost certainly lower before failure. Just because it burns 1,500º doesn't mean it can't melt bent steel either.

How 911 went down according to the new generations of truthers:

Here's a new twisty twist. Wonder if it true or just more disinformation. Spot of embarrassment on the hypothetical alliance and the Saudi 9/11 saga if it is. Maybe the Saudis were just minor investors and didn't appreciate being promoted to chairman of the board.





https://t.me/tribunalsandexecutions/484442

https://t.me/tribunalsandexecutions/484442

Personally, regarding 9/11, I'll never forget the image of those 5 Dancing Arabs on top of that white van.

And how is it that planes that hit the two buildings at around the 80th. floor levels caused explosions in the lobbies and in the basement? Care to esplain Lucy?

RayAmerica says

Personally, regarding 9/11, I'll never forget the image of those 5 Dancing Arabs on top of that white van.

And how is it that planes that hit the two buildings at around the 80th. floor levels caused explosions in the lobbies and in the basement? Care to esplain Lucy?

Well, propaganda cramming and strobing didn't work very well on you. Maybe tying to a chair and gang stalking will do the trick. "Fella, the Matrix is a lot easier than having your knuckles crushed."

Another spot of bother from the alliance.

https://t.me/WW3INFO/48170